CodeMercs Forum

Hi there, I already found where the problem was. Now I get the temperature without problem. At the end of the SHT2x datasheet it states that you can use the same protocol as in SHT7 so I did that based on this entry: http://forum.codemercs.com/viewtopic.php?f=1&t=1694 //sensor first time setup /...

Hi, thanks I tried that, but I always get following result back: 1st read: report[0] = 2 report[1] = 128 2nd read: report[0] = 3 report[1] = 128 and so on... (being the rest of the values 0). which does not seem to me any temperature reading... I have also tried to add the Read Temperature command H...

Hi, yes I took a look at the data sheet. The problem is that writing address 0x80 (128), the iowkit write function gives back 0 bytes written... this is what I do: //Soft reset report[0] = 0x80; //I2c address + write report[1] = 0xFE; // Soft reset ret = IOWarrior.Functions.IowKitWrite(Handle, 1, re...

Hi guys, I am communicating with the Sensirion EKH5 with Sensor SHT2x but I don't know what values I have to write in order to get the proper values of temperature and humidity from the sensor. These values from a SHT75 that I found in this forum: //Init I2C mode report[0] = 0x01; report[1] = 0x01; ...