Hi,
I'm reading the datasheet for JW24MOD-A8-16 and it describes "A0" & "A1" as connection points for the center pins of the 3 pots. Is that designated as "AZ" & "AY" on the module PCB?
If so then is AZ connected to AY and then to the center tap of each pot?
Does each pot require a separate 4.7 nF cap?
Thanks for your help.
Tony
RE: Datasheet AZ and AY on JW24MOD-A8-16 PCB
Moderator: Guido Körber
-
- Site Admin
- Posts: 2857
- Joined: Tue Nov 25, 2003 10:25 pm
- Location: Germany/Berlin
- Contact:
Re: RE: Datasheet AZ and AY on JW24MOD-A8-16 PCB
Have a look at the application cirsuit in the data sheet. That is the same circuit as used on the module.
Re: RE: Datasheet AZ and AY on JW24MOD-A8-16 PCB
Thank you. The 2 page datasheet for the module explains it.
AX, AY, AZ are for connecting the center taps of each pot.
Thanks again.
Tony
AX, AY, AZ are for connecting the center taps of each pot.
Thanks again.
Tony