Guido,
I have it set up so X1 goes to 4 buttons, after button is diode, then to Y1, Y2, Y3, Y4. X1 jumps from button to button, the first button in line registers fine, but the three following buttons register as two buttons when pressed. The X2, X3, X4 groupings work fine. Any touhgts on what is causing the bleed thru.
TY
24 A-15 Button Matrix
Moderator: Guido Körber
-
- Site Admin
- Posts: 2856
- Joined: Tue Nov 25, 2003 10:25 pm
- Location: Germany/Berlin
- Contact:
-
- Posts: 55
- Joined: Thu Dec 01, 2005 7:44 pm
- Location: NYC
ditto
18 inch from module to buttons, 18 inch from buttons to diodes, 1 inch from diode to module, other button groups are twice as far with no problems.
ty
ty
-
- Site Admin
- Posts: 2856
- Joined: Tue Nov 25, 2003 10:25 pm
- Location: Germany/Berlin
- Contact:
-
- Posts: 55
- Joined: Thu Dec 01, 2005 7:44 pm
- Location: NYC
more
I,ve taken a 25 pin printer cable and canablized it. This particular grouping of buttons is using the larger guage wires in the bundle. Are you saying that the magnetic field created by the larger guage wires might be the bleed thru issue?
ty
ty
-
- Site Admin
- Posts: 2856
- Joined: Tue Nov 25, 2003 10:25 pm
- Location: Germany/Berlin
- Contact: