Hi there, can anyone give me an explanation as to how the x and y ports are connected to the physical switches when the IO Warrior is used in switch matrix mode as I am struggling to understand it from reading the data sheet. If someone could give an example of a circuit diagram of say a 2 x 2 matrix of the switches connected up with the diodes, using for example x0..x1 and y0..y1, that would help me a lot. Thanks in advance,
Paul.
Switch Matrix Hardware
Moderator: Guido Körber
-
- Site Admin
- Posts: 2857
- Joined: Tue Nov 25, 2003 10:25 pm
- Location: Germany/Berlin
- Contact:
Switch Matrix Hardware
here...
You do not have the required permissions to view the files attached to this post.
Re: Switch Matrix
Apologies, but the message within the post you sent says:
"You do not have the required permissions to view the files attached to this post."
I am assuming that this was supposed to be a link, and due to my permission level I cannot view it?
Paul.
"You do not have the required permissions to view the files attached to this post."
I am assuming that this was supposed to be a link, and due to my permission level I cannot view it?
Paul.
-
- Site Admin
- Posts: 2857
- Joined: Tue Nov 25, 2003 10:25 pm
- Location: Germany/Berlin
- Contact:
Re: Switch Matrix Hardware
It should work now
Re: Switch Matrix Hardware
no, it does'nt work now
Re: Switch Matrix Hardware
Yeah it still doesn't seem to be working.
-
- Site Admin
- Posts: 2857
- Joined: Tue Nov 25, 2003 10:25 pm
- Location: Germany/Berlin
- Contact:
Re: Switch Matrix Hardware
Now...
For some obscure reason the forum permissions were set wrong only for the English IO-Warrior forum.
For some obscure reason the forum permissions were set wrong only for the English IO-Warrior forum.
Re: Switch Matrix Hardware
Much appreciated, thanks.