RE: Datasheet AZ and AY on JW24MOD-A8-16 PCB

This is the English forum for all topics related to JoyWarrior. Please post in English only

Moderator: Guido Körber

Post Reply
TonyA
Posts: 3
Joined: Sun Dec 13, 2009 2:58 am

RE: Datasheet AZ and AY on JW24MOD-A8-16 PCB

Post by TonyA »

Hi,

I'm reading the datasheet for JW24MOD-A8-16 and it describes "A0" & "A1" as connection points for the center pins of the 3 pots. Is that designated as "AZ" & "AY" on the module PCB?

If so then is AZ connected to AY and then to the center tap of each pot?
Does each pot require a separate 4.7 nF cap?

Thanks for your help.

Tony
Guido Körber
Site Admin
Posts: 2856
Joined: Tue Nov 25, 2003 10:25 pm
Location: Germany/Berlin
Contact:

Re: RE: Datasheet AZ and AY on JW24MOD-A8-16 PCB

Post by Guido Körber »

Have a look at the application cirsuit in the data sheet. That is the same circuit as used on the module.
TonyA
Posts: 3
Joined: Sun Dec 13, 2009 2:58 am

Re: RE: Datasheet AZ and AY on JW24MOD-A8-16 PCB

Post by TonyA »

Thank you. The 2 page datasheet for the module explains it.
AX, AY, AZ are for connecting the center taps of each pot.

Thanks again.
Tony
Post Reply