Dear Sir/Madam,
I am currently doing a project for Photon Fire Ltd using an IOWarrior56. I am using LabView to access the IOWarrior56 by following the information is provided on IOW56-datasheets and the software given by CodeMercs. So far I have created a block diagram where you can see the properties of IOW56 that is connected and enable the IIC mode. Also, with another block diagram I can verify the special mode function is used for IOW56 which is IIC. Although, I have tried in many ways to write and/or read using the IIC_writeA.vi and IIC_readA.vi I always get an error status of 9999. Can you please propose any possible solutions for this error and/or provide me with any detailed procedure for using the IIC mode? Are there any examples for IIC? Is there an email address where I can personally contact the technical support of the company?
Thank you in advance.
Kind regards,
Marinos Loukaidis
Error Status 9999
Moderator: Guido Körber
- Christoph Jung
- Posts: 670
- Joined: Sun Oct 08, 2006 3:43 pm
- Location: Germany / Berlin
- Contact:
Re: Error Status 9999
Could you send me your VI as a LabView 2011 version (support@codemercs.com) or post an image of your block diagram?
- Christoph Jung
- Posts: 670
- Joined: Sun Oct 08, 2006 3:43 pm
- Location: Germany / Berlin
- Contact:
Re: Error Status 9999
Error Status 9999:
The iowkit.dll was not properly closed.
This could happend if you stop a running VI without IowKitClose().
The only way to solve this problem is start another VI with only Open and Close or restart LabView.
The iowkit.dll was not properly closed.
This could happend if you stop a running VI without IowKitClose().
The only way to solve this problem is start another VI with only Open and Close or restart LabView.