Guido,
My A-8 mod is constantly loosing its windows calibration why flying a game. Its the z-axis which is where my rudder is attached.
The x and y are generally ok.
What could be a possible cause of the z-axis consistently loosing its center point?
ty
calibration
Moderator: Guido Körber
-
- Site Admin
- Posts: 2856
- Joined: Tue Nov 25, 2003 10:25 pm
- Location: Germany/Berlin
- Contact:
Re: calibration
There should be nothing on the controller side that could cause this. Unless there is some bug in the Windows software I would suspect a mechanical problem.
-
- Posts: 55
- Joined: Thu Dec 01, 2005 7:44 pm
- Location: NYC
Re: calibration
This is the solution.
In windows, I reset to the default calibration. I then did not do any calibration after that. Reset to default only.
Then in the game I did calibrate my controller. Now everything stays consistent with multiple boots, and logs into the game server. It appears that there was some kind of conflict when calibrating in windows and then calibrating in the game.
I used to have to recalibrate in the game with each logon. Not anymore.
In windows, I reset to the default calibration. I then did not do any calibration after that. Reset to default only.
Then in the game I did calibrate my controller. Now everything stays consistent with multiple boots, and logs into the game server. It appears that there was some kind of conflict when calibrating in windows and then calibrating in the game.
I used to have to recalibrate in the game with each logon. Not anymore.