LW-13 configuration
Posted: Thu Feb 03, 2022 5:07 pm
I can not configure via i2c LW-13 so that the light turns on/off smoothly (single switch). The lamp driver is configured correctly, when commanded by other DALI switches, it turns on/off smoothly.
The manual states that "Though if bit 0 of the address byte is 0 the switch sends an acr power command. In this case address and mode bytes are transmitted as the arc power command when the switch is closed". But I cannot understand what is meant.
What should be the configuration command for fade on/fade off?
And, please explain how to use the LED-Warrior13 configuraror (lw13 config.exe) program.
Thank you.
The manual states that "Though if bit 0 of the address byte is 0 the switch sends an acr power command. In this case address and mode bytes are transmitted as the arc power command when the switch is closed". But I cannot understand what is meant.
What should be the configuration command for fade on/fade off?
And, please explain how to use the LED-Warrior13 configuraror (lw13 config.exe) program.
Thank you.